Skip to main content
O Trucking
Truck Component

Volvo/Mack Aftertreatment (D-series + MP-series engines)

Volvo Group · Aftertreatment / Emissions · DPF + SCR + DEF

Class 8 In production
Aftertreatment / Emissions
Manufacturer
Volvo Group
Category
Aftertreatment / Emissions
Subtype
DPF + SCR + DEF
Class
Class 8

What this component does

Volvo/Mack Aftertreatment is the shared emissions system for Volvo D-series engines (D11/D13/D16) and Mack MP-series engines (MP7/MP8) — same architecture, Volvo Group manufacturing. Used in all Volvo and Mack trucks since EPA 2010. The Volvo/Mack design uses similar DPF + SCR + DEF architecture to other OEMs but with Volvo Group-specific calibration and parts.

Specifications
Manufacturer
Volvo Group
Category
Aftertreatment / Emissions
Subtype
DPF + SCR + DEF
Truck class
Class 8
Production
2010–present
Applications
All Volvo D11/D13/D16, Mack MP7/MP8 engines
Design and engineering

DOC + DPF + SCR + DEF dosing. Volvo Group-engineered. Aftertreatment mounted along chassis. DEF tank 8-15 gallons depending on truck.

Generations
  • Volvo/Mack Aftertreatment Gen 1 (2010–2017)
    EPA 2010 launch.
  • Volvo/Mack Aftertreatment Gen 2 (2017–present)
    EPA 2017 refinements. NOx limits improved.
Reliability and longevity

Comparable to industry — DEF/SCR failures at high mileage are universal.

Common problems

DEF heater failures. NOx sensor degradation. EGR cooler cracking on D13/MP8 at 400K+ miles. DPF plugging.

Maintenance schedule

Standard DEF/DPF/SCR service intervals.

Pros and cons

Pros

  • ✓Shared Volvo/Mack platform — common service parts
  • ✓Volvo Group engineering
  • ✓Strong dealer support

Cons

  • !D13/MP8 EGR cooler issues are well-documented
  • !DEF system failures industry-wide
Trucks that use this component
Related DTC codes
Other Aftertreatment / Emissions components

Related

Frequently Asked Questions

What is the Volvo/Mack Aftertreatment (D-series + MP-series engines) system?
The Volvo/Mack Aftertreatment (D-series + MP-series engines) is the emissions control system for Class 8 trucks with Volvo Group engines. Volvo/Mack Aftertreatment is the shared emissions system for Volvo D-series engines (D11/D13/D16) and Mack MP-series engines (MP7/MP8) — same architecture, Volvo Group manufacturing. Used in all Volvo and Mack trucks since EPA 2010. The Volvo/Mack design uses similar DPF + SCR + DEF architecture t
What is DEF and how much do I use?
DEF (Diesel Exhaust Fluid) is a urea-water solution that's injected into the exhaust stream to convert NOx to harmless nitrogen and water vapor via the SCR catalyst. Typical consumption: 1 gallon DEF per 50 gallons of diesel — about 2% of fuel volume. A typical Class 8 long-haul truck uses 5-7 gallons of DEF per 1,000 miles. DEF is available at all truck stops at $2.50-4.00/gallon.
Why does aftertreatment fail so often?
Modern aftertreatment is the #1 source of unscheduled diesel truck downtime. Common failure modes: DEF heater failures (cold weather), NOx sensor degradation at 200-400K miles, DPF face plugging from short trips or extended idle, EGR cooler cracking, SCR catalyst poisoning from sulfur contamination. Major fleets budget $0.05-0.15/mile for aftertreatment-related maintenance over truck life. Tampering (DPF delete) is illegal — federal fines up to $5,000 per violation under the Clean Air Act.
What are common DTC codes for this aftertreatment?
Common codes: P204F, P207F, P2200, P2459, P226C, P244A, P244B. P204F (DEF heater control circuit) and P207F (DEF system performance) are the most-cited. NOx sensors (P2200-P2228) degrade with mileage. DPF efficiency codes (P0420, P0421) typically mean DPF face plugging or DOC failure.
When does the DPF need to be cleaned?
DPF cleaning intervals vary by duty cycle: highway long-haul (high regen rate) typically 350-400K miles. Regional / mixed: 250-350K. Stop-and-go vocational: 150-250K. The truck will display a "DPF cleaning required" warning when soot accumulation exceeds threshold. Cleaning options: ash cleaning ($800-1,500 at a service center) or DPF replacement ($3,000-6,000). Both are required maintenance — driving past the warning eventually triggers a derate that limits the truck to 5 mph.
Can I delete the DPF and DEF system?
**No — this is federally illegal.** Tampering with emissions controls is a violation of the Clean Air Act (42 USC 7522) with federal fines up to $5,000 per violation, plus state penalties. EPA enforcement has increased in 2022-2024 — over 500 fleet inspections nationwide have resulted in fines for DPF-deleted trucks. CARB in California has zero tolerance. Many oil-field operators delete DPF anyway, accepting the risk. Insurance carriers may deny coverage on deleted trucks. **Do not delete emissions equipment for on-road operation.**

Need help diagnosing a component problem?

Ready to Grow Your Trucking Business?

Dispatch support for your trucking business. Explore our current service options.