OBD-II Diagnostic Trouble Code
P22A6 — Reductant Heater B Control Circuit High
P22A6 indicates the control circuit for reductant heater B is reading high, usually from a short to battery voltage or an open on the controlled side. The heater may stay on or never turn on.
Severity 3/5
Truck-relevant
Service this week
Severity
Service this week
Reductant Heater B Control Circuit High
Code
P22A6
Category
Powertrain
Subsystem
Aftertreatment
Truck-relevant
Yes
What this means for truckers
Service within a few days on a Cummins X15, Detroit DD15, PACCAR MX-13. Performance is likely degraded. Continuing to drive without service risks additional component damage.
Before you replace parts — try this first
P22A6 on the Aftertreatment system is most often control circuit shorted to voltage — not a dead part. On commercial diesels especially, work these in order before spending money on parts:
- Confirm the symptoms. Match what your truck is doing to the Symptoms section below. If the code is set but the symptoms are not there, clear the code and re-test after a drive cycle — it may not return.
- Clean and dry the sensor connector. Water, road salt, or oil seeping into a connector is the #1 fake sensor failure. Disconnect, look for green corrosion or moisture, spray with electrical contact cleaner, dry, reseat. Many faults clear here for $0.
- Inspect the wiring harness. Trace the wire from the sensor toward the ECM — look for chafing against the engine block, melted insulation near the turbo or exhaust, or pinch points where a clamp has rubbed through.
- Test the sensor before swapping it. Most Common Causes (below) list the expected voltage or resistance range — a $20 multimeter saves a $300 sensor swap that does not fix the problem.
- Only then, replace the part. Use the OEM or a tier-1 aftermarket. Cheap sensors throw the same code in two weeks.
Symptoms
Emissions light; possible DEF freezing in cold weather, or a heater that stays on and drains power. A derate may follow if dosing fails.
Common causes
- CommonControl circuit shorted to voltage ($80–$350)
- OccasionalStuck heater relay ($30–$200)
- OccasionalOpen heater element ($150–$700)
- RareControl module fault ($800–$2500)
How to fix
Check the heater relay for sticking
When to use: First check
Check wiring for shorts to power
When to use: When relay is good
Measure heater element resistance
When to use: To rule out an open element
Affects most
No specific vehicle pattern found in our complaint database. This code can appear on any vehicle that supports OBD-II diagnostics.
Related
- → Browse all DTC trouble codes
- → Decode a VIN to check codes for your truck
- → Owner-operator maintenance guides
- → P2200 — NOx Sensor Circuit Bank 1
- → P229E — NOx Sensor Circuit Bank 1 Sensor 2
- → P229F — NOx Sensor Bank 1 Sensor 2
- → P22A4 — Reductant Heater B Control Circuit/Open
- → P22A5 — Reductant Heater B Control Circuit Low
Frequently Asked Questions
Can I drive with code P22A6?
P22A6 is severity 3 — plan service within a few days. Performance is likely degraded already (you may feel reduced power, harsher shifts, or slightly worse fuel economy). Continuing to drive risks additional damage to adjacent components.
How much does it cost to fix P22A6 on a commercial truck?
Total repair cost ranges $30–$2500 depending on the root cause. The cheapest fix is usually the first one listed below — Control circuit shorted to voltage — which is also the most common. On commercial trucks the cost is usually higher than passenger vehicles due to part availability and shop labor rates ($120–185/hour at most truck shops, vs $90–130 at general auto shops). DIY-capable fixes (sensors, hoses, filters) are at the low end; major component replacements (turbo actuator, high-pressure fuel pump, transmission solenoid pack) are at the high end. Always diagnose with a scan tool BEFORE replacing parts — guessing wrong on a $1,500 turbo actuator when the actual issue was a $30 boost hose is a common expensive mistake.
Will P22A6 fail a DOT inspection?
Yes — P22A6 is an emissions-related code, and DOT inspectors check emissions compliance. An active emissions code with a check engine light can result in an out-of-service violation under FMCSA Part 393. The truck typically can't be moved until the code is cleared. Repeated emissions violations escalate to CSA scores.
What's the difference between P22A6 and related codes?
P22A6 is closely related to: P2200 (NOx Sensor Circuit Bank 1), P229E (NOx Sensor Circuit Bank 1 Sensor 2), P229F (NOx Sensor Bank 1 Sensor 2), P22A4 (Reductant Heater B Control Circuit/Open). These codes share the same subsystem (aftertreatment) and often appear together. If you see this code, scan for the full code list — fixing the root cause usually clears multiple companion codes at once. If only P22A6 is set without the companions, the issue is more isolated.
How do I prevent P22A6 from coming back after a repair?
For P22A6 (Reductant Heater B Control Circuit High), prevention centers on the aftertreatment system. Run quality DEF (verify supplier — BlueDEF, PEAK, Yara Air1). Don't skip parked regens — when the dash asks for one, do it. Avoid extended idle time which fouls the DPF. Replace NOx sensors at the OEM interval (typically 400K miles).