OBD-II Diagnostic Trouble Code
P0867 — Transmission Fluid Pressure
P0867 indicates a general transmission fluid pressure fault. The TCM detected that measured fluid pressure does not match the expected value for the operating condition. Exact thresholds vary by transmission.
Severity 4/5
Truck-relevant
Stop within 50 mi
Severity
Stop within 50 mi
Transmission Fluid Pressure
Code
P0867
Category
Powertrain
Subsystem
Transmission
Truck-relevant
Yes
What this means for truckers
P0867 (Transmission Fluid Pressure) — main line pressure is out of range. Either pressure control solenoid stuck or pump issue. Diagnose with a pressure gauge tapped into the trans test port. Don't drive far with this — wrong line pressure burns clutch packs in hours.
Before you replace parts — try this first
P0867 on the Transmission system is most often low fluid level or wrong fluid — not a dead part. On commercial diesels especially, work these in order before spending money on parts:
- Confirm the symptoms. Match what your truck is doing to the Symptoms section below. If the code is set but the symptoms are not there, clear the code and re-test after a drive cycle — it may not return.
- Clean and dry the sensor connector. Water, road salt, or oil seeping into a connector is the #1 fake sensor failure. Disconnect, look for green corrosion or moisture, spray with electrical contact cleaner, dry, reseat. Many faults clear here for $0.
- Inspect the wiring harness. Trace the wire from the sensor toward the ECM — look for chafing against the engine block, melted insulation near the turbo or exhaust, or pinch points where a clamp has rubbed through.
- Test the sensor before swapping it. Most Common Causes (below) list the expected voltage or resistance range — a $20 multimeter saves a $300 sensor swap that does not fix the problem.
- Only then, replace the part. Use the OEM or a tier-1 aftermarket. Cheap sensors throw the same code in two weeks.
Symptoms
Slipping, harsh shifts, delayed engagement, overheating and limp-home mode. Warning light on.
Common causes
- CommonLow fluid level or wrong fluid ($100–$400)
- CommonFaulty pressure sensor or wiring ($150–$700)
- OccasionalClogged filter or worn pump ($300–$2500)
- OccasionalSticking pressure regulator valve ($900–$2800)
How to fix
Check fluid level and type
When to use: First step
Compare scan tool pressure reading to a mechanical gauge
When to use: To separate a sensor fault from a real pressure fault
Replace filter and inspect pump
When to use: When actual pressure is wrong
Replace sensor or repair valve body
When to use: Based on test results
Affects most
No specific vehicle pattern found in our complaint database. This code can appear on any vehicle that supports OBD-II diagnostics.
Related
Frequently Asked Questions
Can I drive with code P0867?
Drive with caution. P0867 is severity 4 — stop within ~50 miles. Most commercial diesel codes at this severity (turbo, fuel rail, transmission solenoid) can damage adjacent expensive components if left unrepaired. Get to a service location before highway-speed loads.
How much does it cost to fix P0867 on a commercial truck?
Total repair cost ranges $100–$2800 depending on the root cause. The cheapest fix is usually the first one listed below — Low fluid level or wrong fluid — which is also the most common. On commercial trucks the cost is usually higher than passenger vehicles due to part availability and shop labor rates ($120–185/hour at most truck shops, vs $90–130 at general auto shops). DIY-capable fixes (sensors, hoses, filters) are at the low end; major component replacements (turbo actuator, high-pressure fuel pump, transmission solenoid pack) are at the high end. Always diagnose with a scan tool BEFORE replacing parts — guessing wrong on a $1,500 turbo actuator when the actual issue was a $30 boost hose is a common expensive mistake.
Will P0867 fail a DOT inspection?
P0867 typically doesn't fail an inspection on its own. Inspectors focus on safety items (brakes, steering, tires, lights, HOS). Transmission codes only become an issue if the truck has shifting problems severe enough to qualify as 'mechanical fitness' OOS. Fix to prevent escalation.
What's the difference between P0867 and related codes?
P0867 is closely related to: P0848 (Transmission Fluid Pressure Sensor/Switch B Circuit), P0868 (Transmission Fluid Pressure Low), P0869 (Transmission Fluid Pressure High). These codes share the same subsystem (transmission) and often appear together. If you see this code, scan for the full code list — fixing the root cause usually clears multiple companion codes at once. If only P0867 is set without the companions, the issue is more isolated.
How do I prevent P0867 from coming back after a repair?
For P0867 (Transmission Fluid Pressure), prevention centers on the transmission system. Service transmission fluid at the OEM interval (typically 150K–250K miles for HD autos). Don't skip the magnet/strainer inspection. After repair, perform an adaptive shift relearn with a scan tool (or drive 40+ miles for adaptive ECMs to relearn naturally).