Skip to main content
O Trucking
OBD-II Diagnostic Trouble Code

P0245 — Turbocharger Wastegate Solenoid A Low

P0245 means the wastegate solenoid A circuit voltage is lower than expected, typically from a short to ground on the control circuit or a lost supply.

Severity 3/5 Truck-relevant
Service this week
Severity
Service this week Turbocharger Wastegate Solenoid A Low
Code
P0245
Category
Powertrain
Subsystem
Turbo
Truck-relevant
Yes
O Trucking From the O Trucking network How to start a trucking business Authority, insurance, MCS-150, and first-load checklist. Start here

What this means for truckers

P0245 (Wastegate Solenoid A Low) — solenoid shorted to ground.

Before you replace parts — try this first

P0245 on the Turbo system is most often control wire shorted to ground — not a dead part. On commercial diesels especially, work these in order before spending money on parts:

  1. Confirm the symptoms. Match what your truck is doing to the Symptoms section below. If the code is set but the symptoms are not there, clear the code and re-test after a drive cycle — it may not return.
  2. Clean and dry the sensor connector. Water, road salt, or oil seeping into a connector is the #1 fake sensor failure. Disconnect, look for green corrosion or moisture, spray with electrical contact cleaner, dry, reseat. Many faults clear here for $0.
  3. Inspect the wiring harness. Trace the wire from the sensor toward the ECM — look for chafing against the engine block, melted insulation near the turbo or exhaust, or pinch points where a clamp has rubbed through.
  4. Test the sensor before swapping it. Most Common Causes (below) list the expected voltage or resistance range — a $20 multimeter saves a $300 sensor swap that does not fix the problem.
  5. Only then, replace the part. Use the OEM or a tier-1 aftermarket. Cheap sensors throw the same code in two weeks.
Symptoms

Check engine light, abnormal boost and possible derate.

Common causes
  • CommonControl wire shorted to ground ($100–$400)
  • CommonFailed (shorted) solenoid ($150–$450)
  • OccasionalOpen supply circuit or blown fuse ($50–$300)
  • RareECM fault ($1200–$3500)
How to fix
Check supply and control at the solenoid
When to use: First step
Check wiring for shorts to ground
When to use: When voltage is low
Replace the solenoid
When to use: When wiring is good
Affects most

No specific vehicle pattern found in our complaint database. This code can appear on any vehicle that supports OBD-II diagnostics.

Related

Frequently Asked Questions

Can I drive with code P0245?
P0245 is severity 3 — plan service within a few days. Performance is likely degraded already (you may feel reduced power, harsher shifts, or slightly worse fuel economy). Continuing to drive risks additional damage to adjacent components.
How much does it cost to fix P0245 on a commercial truck?
Total repair cost ranges $50–$3500 depending on the root cause. The cheapest fix is usually the first one listed below — Control wire shorted to ground — which is also the most common. On commercial trucks the cost is usually higher than passenger vehicles due to part availability and shop labor rates ($120–185/hour at most truck shops, vs $90–130 at general auto shops). DIY-capable fixes (sensors, hoses, filters) are at the low end; major component replacements (turbo actuator, high-pressure fuel pump, transmission solenoid pack) are at the high end. Always diagnose with a scan tool BEFORE replacing parts — guessing wrong on a $1,500 turbo actuator when the actual issue was a $30 boost hose is a common expensive mistake.
Will P0245 fail a DOT inspection?
P0245 itself doesn't automatically fail an inspection, but if the truck is in reduced-power mode (limp mode) at the time of inspection, it WILL be flagged. Most inspectors will note the check engine light but pass the truck if it's running and performance is normal. Fix it before a Level 1 inspection regardless.
What's the difference between P0245 and related codes?
P0245 is closely related to: P0200 (Injector Circuit Malfunction), P0201 (Injector Circuit Malfunction - Cylinder 1), P0202 (Injector Circuit Malfunction - Cylinder 2), P0203 (Injector Circuit Malfunction - Cylinder 3). These codes share the same subsystem (turbo) and often appear together. If you see this code, scan for the full code list — fixing the root cause usually clears multiple companion codes at once. If only P0245 is set without the companions, the issue is more isolated.
How do I prevent P0245 from coming back after a repair?
For P0245 (Turbocharger Wastegate Solenoid A Low), prevention centers on the turbo system. Inspect boost piping at every PM service. Replace silicone boost hoses preventively at 250K miles. Run quality diesel fuel (low ash, high cetane) to keep VGT vanes from carbon-locking. After repair, drive 30 miles of mixed-load conditions to let the ECM relearn boost calibration.

Need help diagnosing a tough engine code?

Ready to Grow Your Trucking Business?

Dispatch support for your trucking business. Explore our current service options.